Alloy wheel 9x18 matt black ET +16 Jeep Wrangler JK 07-17 with TÜV certificate

Alloy rim black matt 9x18 ET + 16 Jeep Wrangler JK from 2007 with TÜV certificate!

The following tire sizes are in the opinion:

• 265/70 R 18? 116 *) (U = 2530 mm) 1), 2), 3), 5), 5a), 6), 7), 8)
• 275/65 R 18? 113 *) (U = 2485 mm) 1), 2), 3), 5), 6), 8)
• 275/70 R 18? 114 *) (U = 2490 mm) 1), 2), 3), 5), 6), 8)
• 285/65 R 18? 125 *) (U = 2520 mm) 1), 2), 3), 5), 5a), 7), 6), 8)
• 305/60 R 18? 118 *) (U = 2530 mm) 1), 2a), 3), 4), 5), 5a), 6), 7), 8)
• 325/60 R 18? 121 *) (U = 2570 mm) 1), 2a), 3), 4), 5), 5a), 6), 7), 8)
• 33 x 12.50 R 18? 114 *) (U = 2520 mm) 1), 2a), 3), 4), 5), 5a), 6), 7), 8)
  
  
• 1) Only front and rear tires and wheels of one make and one type are allowed.
  *) ... The required speed index can be found in the vehicle documents.
  The suitability of the tires used, in particular the required tire inflation pressure in conjunction with the existing load index at the respective maximum speed, the maximum axle loads and camber values u200bu200band, when using different tire sizes front and rear also the usability in connection with electronic Control systems (ABS, ASR, etc.) must be verified by the tire manufacturer.
  If the tire inflation pressure differs from the standard pressure, the vehicle driver must be advised accordingly (air pressure sticker, supplementing the operating instructions).
• 2) The front and rear wheelhouses shall be adequately covered by suitable parts or by other appropriate means. Depending on the condition of the vehicle (eg lowered vehicle, wheel cover widening, etc.) it may be possible that the wheel cover is sufficient.
• 2a) The front and rear wheelhouses shall be adequately covered by suitable parts or by other appropriate means.
• 3) The circlips on the front and rear wheel bolts must be removed.
• 4) By limiting the steering stop, make sure that there is sufficient clearance to the stabilizer. Depending on the tolerance of the vehicle, it may be possible that the clearance is sufficient.
• 5) On vehicles with the standard 245 / 75R16 tires, it is necessary to check and, if necessary, readjust the speedometer. If a readjustment is made, the standard tires can only be used optionally if it can be shown at the same time that the speedometer setting is still in compliance with these tires.
• 5a) It is necessary to check and, if necessary, readjust the speedometer. If a readjustment is made, the standard tires can only be used optionally if it can be shown at the same time that the speedometer setting is still in compliance with these tires.
• 6) The use of snow chains is not permitted.
• 7) Due to the increased rolling circumference, the wheel load is reduced to the following values: U = 2520 mm? Load capacity of the special wheel: 720 kg U = 2530 mm? Load capacity of the special wheel: 718 kg U = 2570 mm? Load capacity of the special wheel: 707 kg Accordingly, the permissible rear axle load must be reduced in conjunction with this wheel / tire combination. A reduction of the front axle load is not permitted.